# cd vpnclient
 # ./vpnclient start (if you have not rebooted after the installation you do not need to run this)
 # ./vpncmd /client localhost
 Import one of the ibVPN Softether config files
 # VPN Client> accountimport <config_files> ex: accountimport ibVPN-UK-London-1.vpn
 Set the password for the imported connection
 VPN Client>accountpasswordset
 AccountPasswordSet command - Set User Authentication Type of VPN Connection
 Setting to Password Authentication
 Name of VPN Connection Setting: ibVPN-UK-London-1
 Please enter the password. To cancel press the Ctrl+D key.
 Password: ********
 Confirm input: ********
 Specify standard or radius: radius
 The command completed successfully.

STEP 4. Check if the settings have been imported:

 VPN Client>accountlist
     AccountList command - Get List of VPN Connection Settings
     Item                                             |Value
     ----------------------------+--------------------------------------------
     VPN Connection Setting Name    | ibVPN-UK-London-1
     Status                                          |Offline
     VPN Server Hostname                |uk3.ibvpn.com:443 (Direct TCP/IP Connection)
     Virtual Hub                                  |VPN
     Virtual Network Adapter Name    |ibvpn
 The command completed successfully.

STEP 5. Connect to the VPN server:

 VPN Client> accountconnect <vpn_connection_setting_name> ex: accountconnect ibVPN- UK-London-1
 Run "accountlist" again to check the server status, it should now be Connected
 Exit vpncmd and run ifconfig
 # VPN Client> exit
 # ifconfig
 Look for adapter name "vpn_ibvpn":
  vpn_ibvpn: flags=4163<UP,BROADCAST,RUNNING,MULTICAST> mtu 1500
 inet6 fe80::2ac:63ff:fed9:de8a prefixlen 64 scopeid 0x20
 ether 00:ac:63:d9:de:8a txqueuelen 1000 (Ethernet)
 RX packets 3110 bytes 442817 (432.4 KiB)
 RX errors 0 dropped 0 overruns 0 frame 0
 TX packets 1641 bytes 136676 (133.4 KiB)
 TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0
 Notice the adapter has no IP address allocated by the VPN server. In order to acquire an address from the server you will have to run:
 # dhclient vpn_ibvpn
 # ifconfig
 The adapter should now display a valid IP address:
 vpn_ibvpn: flags=4163<UP,BROADCAST,RUNNING,MULTICAST> mtu 1500
 inet 10.10.110.147 netmask 255.0.0.0 broadcast 10.255.255.255